Submissions

Online Submissions

Already have a Username/Password for Journal of Innovation and Applied Technology?
Go to Login

Need a Username/Password?
Go to Registration

Registration and login are required to submit items online and to check the status of current submissions.

 

Author Guidelines

Author Guideline can be downloaded here.

Writing should be submitted according to the following restrictions:

  1. Manuscript should be written in English and be submitted online via journal website. Online Submission will be charged at no Cost. Author must login in order to make submission.
  2. Manuscript should not exceed 10 pages including embedded figures and tables, without any appendix, and the file should be in Microsoft Office (.doc/.docx) or Open Office (.odt) format. It should be prepared  in A4 paper (21cm x 29.7cm) using 2.5 cm for inside margin and 2 cm for top, bottom, and outside margins.
    1. Title, Abstract, and Keywords should be written in English
  • Title should be less than 15 words, title case, small caps, centered, bold, font type Arial, font size 11, and single spaced, writing should be in single columns with 1 cm colom spacing
  • Abstract contains neither pictures nor tables, justified, in 11 italic Arial, single spaced, and should not exceed 250 words, writing should be in two columns with 1,15 cm colom spacing
  • Keywords contain three to five words/phrases separated with coma and should be justified, 11 italic, bold Arial and single spaced.
  1. Manuscript body.
  • The main text of the writing should be in two columns with 1,15 cm colom spacing, justified, 11 Arial, first line indent 5 mm, and 1,15 spaced.
  • Consists of: Introduction, Main Content (Method/Material/etc), Result and Discussion, and Conclusion; followed by Acknowledgment and References.
  1. Heading should be made in four levels. Level five cannot be accepted.
  • Heading 1: title case, Uppercase, center aligned, bold, 11 Arial, 1,15 spaced,
  • Heading 2: title case, left aligned, bold, 11 Arial, 1,15 spaced, Capitalize Each Words with or no numbered followed by dot
  • Heading 3: title case, left aligned, italic, 11 Arial, 1,15 spaced, numbered by number followed by closed bracket
  • Heading 4 is not recommended, however, it could still be accepted with the format of: sentence case, left indent 5 mm, hanging indent 5 mm, italic, 11 Arial, single spaced, numbered by small cap followed by closed bracket
  • Heading 5 cannot be accepted in the manuscript.
  1. Figure and table should be in black and white, and if it is made in color, it should be readable when it is later printed in black and white. Figure and table should be clearly readable and in a proportional measure to the overall page. Caption should be numbered, in 10 Arial and 1,15 spaced. For layouting purpose, please provide the respective captioned figure/table in with extension .tif/.jpg/.jpeg within a particular folder apart from the manuscript.
    1. Mathematical equation should be clearly written, numbered orderly, and accompanied with any information needed.
  2. Header and footer including page number must not be used. All hypertext links and section bookmarks will be removed from papers. If you need to refer to an Internet email address or URL in your paper, you must type out the address or URL fully in Regular font.
    1. Citation and Reference are written according to IEEE style
  • Citations numbering should be numbered in [1], [2], [3], ... format, according to appearance order.
  • Wikipedia, personal blog, or non scientific website is not allowed to be taken into account.
  • Primary references should be at least 80% from at least ten references.
  • References shoul be taken from the late five years.
  • Detail referencing manual can be seen in the Author Guideline

 

The Board is authorized to reject a manuscript based on peer reviewer advice and make a necessary changes or adjustment related with language properties without altering the substance. Substance editing would be consulted with the author first.

 

Submission Preparation Checklist

As part of the submission process, authors are required to check off their submission's compliance with all of the following items, and submissions may be returned to authors that do not adhere to these guidelines.

  1. The submission has not been previously published, nor is it before another journal for consideration (or an explanation has been provided in Comments to the Editor).
  2. The submission file is in OpenOffice, Microsoft Word, RTF, or WordPerfect document file format.
  3. Where available, URLs for the references have been provided.
  4. The text is single-spaced; uses a 12-point font; employs italics, rather than underlining (except with URL addresses); and all illustrations, figures, and tables are placed within the text at the appropriate points, rather than at the end.
  5. The text adheres to the stylistic and bibliographic requirements outlined in the Author Guidelines, which is found in About the Journal.
  6. If submitting to a peer-reviewed section of the journal, the instructions in Ensuring a Blind Review have been followed.
 

Copyright Notice

The author whose published manuscript approved the following provisions:
 
1. The publication rights of all journal material published/published on JIAT's Journal of Innovation and Applied Technology website are held by the editorial board with the author's knowledge (moral right remains by the scriptwriter), the authors agree to automatic transfer of the copyright to the publisher.
 
2. The formal legal provisions for access to digital articles of this electronic journal are subject to the terms of the Creative Commons Attribution (CC BY) license, which means that JIAT (Journal of Innovation and Applied Technology) reserves the right to save, transfer media / format, in the form of database, maintain, and publish articles without requesting permission from the Author as long as it keeps the author's name as the owner of Copyright.
 
3. Printed and published print and electronic manuscripts are open access for educational, research and library purposes. In addition to these objectives, the editorial board shall not be liable for violations of copyright law.

4. All articles in JIAT can be re-used and re-distributed without restriction, as long the original work is properly cited.

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.

 

ORIGINALITY STATEMENT

the author should be entirely original and plagiarism in any form is unethical and unacceptable

Download Template Declaration of Originality and Assignment of Author Rights here

1. the author should be entirely original and plagiarism in any form is unethical and unacceptable
2. All articles will be submitted to the Turnitin plagiarism checker

 

Privacy Statement

The names and email addresses entered in this journal site will be used exclusively for the stated purposes of this journal and will not be made available for any other purpose or to any other party.

 

Author Fees

This journal charges the following author fees.

Article Submission: 0.00 (IDR)

Article Publication: 0.00 (IDR)

If you do not have funds to pay such fees, you will have an opportunity to waive each fee. We do not want fees to prevent the publication of worthy work.